Installation guide

Installing your LuxAir fan

Installation takes an average of 30-45 minutes. If you have an existing connection point in the ceiling, you don't need an electrician. Read this guide completely before you start.

Multilingual installation manual included Every LuxAir fan comes with a comprehensive installation manual including step-by-step illustrations. This online guide is supplementary.

Safety first. Always switch off the power circuit at the meter cabinet before you start. Use a voltage tester to check that there is no power on the wires.

What you need

Phillips screwdriver

Flat-head screwdriver

Spirit level

Pen or pencil

Ladder

Voltage tester (recommended)

Drill (if no existing ceiling anchor)

Optional: insulating tape

Step by step

Turn off power

Switch off the power circuit at the meter cabinet. Use a voltage tester to verify there is no power on the wires. This is the most critical step — never skip it.

Mount housing

Remove the ceiling housing from the box. Attach the ceiling anchor to the junction box in your ceiling with the supplied screws. Make sure the anchor is level.

Connect wires

There are usually three wires: brown/red = live (L), blue = neutral (N), green/yellow = earth (PE). Connect the wires via the supplied wire connectors. Not sure? Consult an electrician.

Secure housing

Slide the housing against the ceiling and secure it to the anchor. Make sure all wires are tucked neatly away.

Mount blades

Attach the three blades to the motor mount. Each blade is secured with two screws. Do not overtighten.

Mount lamp

Mount the LED lighting frame to the bottom of the motor. Connect the lighting cable and secure the frame.

Turn on power and test

Switch the power circuit back on. Test the fan on all speeds and the lighting on all color temperatures.

Set rotation direction

Use the remote to switch between summer and winter mode.

Remote control

All buttons explained

Fan on/off

Turns the fan on or off. The fan remembers the last setting.

Speed +/-

Six speeds available. Speed 1 is whisper-quiet, speed 6 is maximum airflow.

Rotation direction

Switches between summer mode (air down) and winter mode (air up).

Light on/off

Switches LED lighting on or off, independent of the fan.

Color temperature

Switches between 3000K (warm), 4500K (neutral) and 6000K (cool).

Timer

Set an automatic shutoff: 1, 2, 4 or 8 hours.

Troubleshooting

Something not working?

The fan does not respond to the remote

Check the batteries (2x AAA). Make sure you are within 6 meters without obstacles. Reset the remote by holding the on/off button for 5 seconds.

The fan vibrates or makes noise

Check all blades are firmly attached and the ceiling mount is secure. Light vibration on first start is normal.

The lighting flickers

Check the lighting cable is properly connected. Turn off power and reconnect the connector.

The fan runs but the light does not work

The lighting cable may not be properly connected. Turn off power and reconnect.

No movement after switching on

Check the power circuit is on and wiring is correct. When in doubt: consult an electrician.

Need help?

We'd be happy to help. Send us a message.